Fukushima Daiichi Frozen Wall Section Fails

A section of the frozen wall at Fukushima Daiichi has melted. The portion south of unit 4 has had problems remaining fully frozen for years. Now TEPCO admits it has melted in recent weeks. This portion of the frozen wall has had issues for years. Recent changes to the nearby K drainage tunnel and a recently discovered crack may be redirecting water from an underground stream into the area of the frozen wall.

TEPCO found sections near the surface of the wall had fully melted. Puddled water was found nearby. The section is relatively small and didn’t impact the lower depths of the wall’s integrity.

fukushima daiichi frozen wall unit 4 section melted 11 2021

TEPCO’s solution is to install steel piling sections between the K drainage canal and this section of the wall, hoping to deflect underground water. This steel wall will not be completely solid. Due to the nature of driving pilings into the ground, there could be gaps as wide as 10 cm.

fukushima daiichi frozen wall unit 4 section melted steel wall

Once the pilings are installed, TEPCO plans to monitor the area to make sure the problem has been resolved.

NHK report on the incident

TEPCO report on the incident (in Japanese)

This article would not be possible without the extensive efforts of the SimplyInfo research team
Join the conversation at chat.simplyinfo.org

© 2011-2023 SimplyInfo.org, Fukuleaks.org All Rights Reserved Content cited, quoted etc. from other sources is under the respective rights of that content owner. If you are viewing this page on any website other than http://www.simplyinfo.org (or http://www.fukuleaks.org) it may be plagiarized, please let us know. If you wish to reproduce any of our content in full or in more than a phrase or quote, please contact us first to obtain permission.

Editor

Editor, SimplyInfo.org

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

%d bloggers like this: